Makita DHP481ZJ Manuel D'instructions page 5

ENGLISH (Original instructions)
1. Red indicator
2. Button
3. Battery cartridge
4. Star marking
5. Indicator lamps
6. Check button
7. LED display
8. Switch trigger
9. Lamp
10. Reversing switch lever
SPECIFICATIONS
Capacities
No load speed min
Blows per minute
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for impact drilling in brick, concrete
and stone. It is also suitable for screw driving and drilling
without impact in wood, metal, ceramic and plastic.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
CORDLESS HAMMER DRIVER
DRILL SAFETY WARNINGS
1. Wear ear protectors when impact drilling.
Exposure to noise can cause hearing loss.
2. Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
Explanation of general view
11. Speed change lever
12. Action mode changing ring
13. Arrow
14. Adjusting ring
15. Graduation
16. Protrusion
17. Arm
18. Groove
19. Grip pole
20. Side grip
Model
Drilling into concrete
Drilling into steel
Drilling into wood
Fastening wood screw
Fastening machine screw
-1
Overall length
Net weight
Rated voltage
ENE079-1
GEA010-1
GEB056-5
High (2)
Low (1)
High (2)
Low (1)
3. Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring. Cutting
accessory contacting a "live" wire may make exposed
metal parts of the power tool "live" and could give the
operator an electric shock.
4. Hold power tool by insulated gripping surfaces,
when performing an operation where the fastener
may contact hidden wiring. Fasteners contacting a
"live" wire may make exposed metal parts of the
power tool "live" and could give the operator an
electric shock.
5. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
6. Hold the tool firmly.
7. Keep hands away from rotating parts.
8. Do not leave the tool running. Operate the tool
only when hand-held.
9. Do not touch the bit or the workpiece immediately
after operation; they may be extremely hot and
could burn your skin.
10. Some material contains chemicals which may be
toxic. Take caution to prevent dust inhalation and
skin contact. Follow material supplier safety data.
21. Sleeve
22. Bit holder
23. Bit
24. Depth rod
25. Clamp screw
26. Hook
27. Screw
28. Blow-out bulb
DHP481
16 mm
13 mm
76 mm
10 mm x 90 mm
6 mm
0 - 2,100
0 - 550
0 - 31,500
0 - 8,250
205 mm
2.7 kg
D.C. 18 V
5