Publicité
Les langues disponibles
Les langues disponibles
The life span of the product can be reduced and the risk
of accidents can increase if product maintenance is not
carried out correctly and if service and/or repairs are not
carried out professionally. If you need further information
please contact your nearest servicing dealer.
WARNING:
damaged safety components. The product's
safety equipment must be inspected and
maintained as described in this section.
If your product fails any of these checks,
contact your service agent to get it repaired.
CAUTION:
on the machine requires special training.
This is especially true of the machine's
safety equipment. If your machine fails
any of the checks described below you
must contact your service agent. When
you buy any of our products we guarantee
the availability of professional repairs and
service. If the retailer who sells your
machine is not a servicing dealer, ask him
Introduction
WARNING:
safety chapter before you assemble the
product.
To install the handguard
1. Unfold the handguard clamp and put it on the shaft.
Make sure that the tab on the shaft is in the groove
on the bottom of the handguard clamp. (Fig. 18)
2. Fold the handguard clamp around the shaft and
tighten the 2 screws.
To adjust the harness
Always use the harness when you operate the product.
The harness gives maximum control during operation of
the product. The harness decreases the risk of tiredness
in your arms and back.
1. Put on the harness.
2. Attach the product to the harness support hook.
3. Adjust the length of the harness until the support
hook is approximately level with your right hip. (Fig.
13)
WARNING:
occurs, let go of the product and let it
fall to the ground.
8
Never use a product with
All servicing and repair work
Assembly
Read and understand the
If an emergency
for the address of your nearest service
agent.
Safety instructions for maintenance
Read the warning instructions that follow before you use
the product.
•
Always stop the product before you work on any part
of the cutting equipment. Remove the battery and
make sure that the cutting equipment has stopped
completely before you start any work on it.
•
The transport guard should always be fitted to the
cutting attachment when the product is not in use.
•
Make sure that the cutting attachment has
stopped before cleaning, carrying out repairs or an
inspection.
•
Always wear heavy-duty gloves when repairing the
cutting attachment. This is extremely sharp and can
easily cause cuts.
(Fig. 17)
•
Store the product out of reach of children.
•
Use only original spare parts for repairs.
To install the storage hook on the wall
•
Install the storage hook indoors.
•
Keep the storage hook out of sunlight and in ambient
temperature of -10°C to 70°C.
•
Install the storage hook on a drywall, wood or
concrete wall.
CAUTION:
can hold loads of minimum 30 kg.
•
Install the storage hook on the wall with the 3 screws
(A). Use wall plugs (B) if it is necessary. (Fig. 19)
CAUTION:
screws are applicable for your wall type.
•
Speak to your Husqvarna service agent for
information about available storage accessories for
your product.
To hang the product on the storage
hook
•
Hang the pole hedge trimmer attachment on the
storage hook as shown in the illustration. (Fig. 20)
Make sure that the wall
Make sure that the
2206 - 005 - 28.06.2024
Publicité
