Publicité
Les langues disponibles
Les langues disponibles
PD port
[
1 ]
charged. The charging process will start automatically. When a PD
enabled device is charged at the Type C port, the fourth LED of the
battery capacity indicator lights up green.
In case if the charging process does not begin immediately, press
*
the ON / OFF button
current battery status of the power bank
charging process by the LED indicator for battery capacity
To end the charging process, disconnect the USB charging cable
*
from the mobile device and the power bank
switch OFF after approx. 30 seconds.
Or simply double click with ON / OFF button
*
and the LED indicator for battery capacity
NOTE:
1. If you use all the USB ports, a voltage of 5 V will output at the
outputs. The maximum output current must not exceed 3.0 A for all
outputs. If all USB outputs are used, fast charge is not possible.
2. If USB type A output
mode, and another USB port is connected to another device for
charging, the quick charge mode or PD mode will be terminated and
switched to normal charge mode. All devices will now be charged at
5 V each.
If the product is not used for a long time, the built-in battery should be
*
fully charged to prolong its operating life. Regularly charge the built-
in battery if you do not use the product for a long period of time. This
is necessary to preserve the battery.
˜ Troubleshooting
= Problem
= Cause
= Solution
The power bank
It may be that the power bank is not connected properly.
Check that it is connected.
In order to charge the power bank, use a power supply with an output
voltage and current matching the rated input voltage and current as
stated in „Technical specifications" of this user manual.
30 GB/IE
of the power bank and the PD port of the device to be
briefly to begin the charging process. The
6 ]
[
or PD port
2 ]
[
is not being charged.
3 ]
[
is displayed during the
3 ]
[
. The power bank will
3 ]
[
. The power bank
6 ]
[
will switch off.
7 ]
[
is in quick charge or PD
1 ]
[
.
7 ]
[
Publicité
