Publicité
Les langues disponibles
Les langues disponibles
*This is approx percentage of power bank capacity but not actual
measurement.
NOTE: The 4th LED light will turn green when the power bank is
charged via PD input port
conventional USB charger is used for charging, the 4th LED will still be the
original colour of the battery status indicator.
m
ATTENTION! Do not connect any device to be charged to power
bank as long as the power bank is charging. Remove the charging
cable from the power bank when it is fully charged.
˜ Checking the battery status
You can check the battery status via the LED indicator
bank
at anytime.
[
3 ]
Briefly press the ON / OFF button
*
the approximate charge status of the internal battery capacity level
for approx. 30 seconds.
˜ Charging mobile devices with the power bank
You can charge up to two devices at the same time using the power
bank
. If all outputs are used at the same time, the sum of the output
[
3 ]
current may not exceed 3 A.
To charge your QuickCharge 3.0 enabled device, connect the
*
USB Type A plug of USB cable
Type C charging cable of the device to be charged to the USB type A
output
which supports QuickCharge 3.0. Then connect the USB
2 ]
[
Type C plug of the USB cable
device to be charged. The charging process will start automatically.
When a QuickCharge enabled device is charged at the Type A port,
the fourth LED of the battery capacity indicator lights up green.
NOTE: You could also charge your conventional USB devices from
the USB Type A output port
cable
or a USB Type A to micro USB cable (not included).
4 ]
[
To charge your USB Power Delivery (PD) enabled device, connect
*
the USB Type C plugs of your USB Type C to Type C cable to the
using a PD-enabled USB charger. If a
1 ]
[
6 ]
[
or the original USB Type A to USB
4 ]
[
to the USB Type C input port of the
4 ]
[
of the power bank using the included USB
2 ]
[
of the power
[
7 ]
. The LED indicator
shows
7 ]
[
GB/IE
29
Publicité
