BGS technic 1523 Mode D'emploi page 3

ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-
compliance of the safety instructions may lead to damage, personal injury and to termination of the
warranty. Keep these instructions in a safe and dry location for future reference. Enclose the
operating instructions when handing over the product to third parties.
INTENDED USE
This device allows adjusting the wheel camber after the disassembly of wheel bearings, shock
absorbers etc. By applying the water gauge to the wheel case you can determine and adjust the
suspension strut angle before the disassembly and after reassembly. Any further measurements of
the axle after maintenance are not necessary. This helps to cut back on expenses and expenditure of
time. Range: 5° positive to 5° negative in 0.5° increments.
SAFETY INFORMATIONS
 Keep children and other persons away from the working area.
 Do not allow children to play with this tool or its packaging.
 Do not use the tool if parts are missing or damaged.
 Use the tool for the intended purpose only.
 This manual is just brief information and will not replace a garage handbook.
 Always consult specific service literature for repair, adjustments and check-ups. This way you
will avoid false diagnoses and wrong assemblies or adjustments that may harm your vehicle or
its components.
 Any repair should be carried out by qualified personnel!
 If you remove the ignition key before repairing, you can prevent the engine from being started
accidentally and personal injuries.
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste. Packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with
the environment. Contact your local solid waste authority for recycling information.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Magnetic Camber Gauge
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 1523
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed