Publicité
Les langues disponibles
Les langues disponibles
Installation Manual
Step 8.
Connect the electrical wiring to the charger.
• Fold the wire ends to pass through the conduit and insert them into the input hole (choose input
direction 1 – rear or 2 - bottom and open cap). Secure charger onto mounting bracket.
1
• For rear or bottom hole installation, use an appropriate conduit (1 inch conduit is recommended)
which meets the NEMA 4 standard.
Refer to the following wire specification. Use a conductor type other than RHH,
RHW and RGW-2 with outer covering. Choose the appropriate conductors in ac-
cordance with all applicable, state, local and national electric codes and stan-
dards.
The stripping length of the wire is recommended to be 15mm+/-0.5mm.
Model
Ford Pro AC
Charging Station
80A (series 2)
2
Figure 4.12 Cable Input Position
Terminal
L1, L2
G
80A Charging Station Series 2
1
2
Conductor
2 AWG
8 AWG
25
1
2
Rating
90°C copper wire
Publicité
