Publicité
Les langues disponibles
Les langues disponibles
Installation Manual
Step 3.
Remove the mounting bracket by sliding the bracket down and off the
charger.
Step 4.
Secure the main body mounting bracket to the wall with appropriate
screws.
Follow applicable accessibility requirements for the mounting position. The unit
shall be stored or located at a sufficient height. For indoor site, it should be in-
stalled between 18 inches (450 mm) and 4 feet (1.2m) above ground. For outdoor
site, it should be installed between 24 inches (600 mm) and 4 feet (1.2m) above
ground. Refer to Article 625, NEC.
The mounting bracket has ten screw holes. If only two screws be used to fasten
the mounting bracket, the screws should pass through the middle two screw holes
of the mounting bracket. The other screw holes are reserved for the user.
Figure 4.5 Remove the Mounting Bracket
Figure 4.6 Fasten Mounting Bracket
80A Charging Station Series 2
21
Publicité
