Télécharger Imprimer la page

sauermann Si-PRO-U-W Guide De Démarrage Rapide page 3

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 4
Wrong screw fixing: scews are
not tight enough
The probe is not correctly fixed on
the wall and the tightness is not
guaranteed.
3. Si-PRO-U-I-100-H probe
The Si-PRO-U-I-100-H needs to work in
combination with the Si-PRO-T-150 probe
or any 3-wire Pt100 probe connected to the
Si-C320 transmitter using the Si-ACC-ETP
accessory. This will allow the Si-Pro-U-I-100-H
to provide relative humidity and temperature
measurements.
The temperature indications on the
transmitters/probes refer only to the
measuring range of the transmitters. Do
not subject the handles or power cables
to temperatures above 50°C (122°F)
if they are not expressly designed for
higher temperatures.
After the measurements, before storing
the probe, wait for the probe to cool
down. A hot probe can cause burns.
Follow these important steps to get the most accurate measurements:
Place the entire Si-PRO-U-I-100-H probe into your measurement environment. If
the Si-PRO-T-150 probe is used, it must be placed entirely into the measurement
environment and close to the Si-PRO-U-I-100-H probe.
Enter manually the atmospheric pressure in the Si-C320 transmitter (see the
complete user manual of the Si-C320).
Wrong screw fixing: scews are
too deep
The filter can be damaged, the
measurements will be affected and the
tightness is no longer guaranteed.
Si-PRO-U-I-100-H
Si-PRO-T-150

Publicité

loading

Ce manuel est également adapté pour:

Si-pro-u-i-100-h