Publicité
Les langues disponibles
Les langues disponibles
Lubrication
Refer to Saw Chain and Guide Bar Oiling (Fig. L)
Cleaning
WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.
WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
Optional Accessories
WARNING: Since accessories, other than those offered
by D
WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
Rechargeable Battery Pack
This long life battery pack must be recharged when it fails
to produce sufficient power on jobs which were easily done
before. At the end of its technical life, discard it with due care for
our environment:
•
Run the battery pack down completely, then remove it from
the tool.
•
Li-Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly.
WALT recommended
e
TROUBLESHOOTING
Problem
Solution
Unit will not start.
•
Check battery installation.
•
Check battery
charging requirements.
•
Check that lock off is fully pushed
down prior to moving main trigger.
Unit shuts down
•
Charge battery.
in use.
•
Unit is being forced. Restart and
apply less pressure.
Battery
•
Insert battery into charger until red
won't charge.
charging light illuminates. Charge up
to 8 hours if battery is totally drained.
•
Plug charger into a working outlet.
Refer to Important Charging Notes
for more details.
•
Check current at receptacle by
plugging an appliance.
•
Check to see if receptacle is
connected to a light switch which
turns power off when you turn out
the lights.
•
Move charger and appliance to
a surrounding air temperature of
above 4.5 °C or below 40.5 °C.
Bar /
•
Refer to Adjusting Chain
Chain overheated.
Tension section.
•
Refer to Chain Oiling section.
Chain is loose.
•
Refer to Adjusting Chain
Tension section.
Poor cut quality.
•
Refer to Adjusting Chain
Tension section. nOTE: Excessive
tension leads to excessive wear and
reduction in life of bar and chain.
Lubricate before each cut. Refer to
Replacing the Saw Chain section.
Unit runs but does
•
Chain could be installed backwards.
not cut.
Refer to sections for installing and
removing chain.
Unit does not oil.
•
Refill oil reservoir.
•
Clean guide bar, sprocket and
sprocket cover. Refer to Care And
Maintenance section.
EnGLIsh
49
Publicité
