Clatronic HM 3775 Mode D'emploi page 27

Overview of the Components /
Scope of Delivery
1 Release button
2 5-stage speed switch
3 TURBO button
4 Mains lead
5 Housing
6 Beaters
7 Ring marking
8 Dough hooks
Notes for Use
• For best results, use high-quality containers that are not
too big.
• In order to avoid splashing, always submerge the dough
hooks or beaters fully into the food to be mixed before
switching on the appliance.
• Short-term operation: Do not operate the mixer for
more than 3 minutes. Then let it cool down for approxi-
mately 10 minutes before using it again.
• The appliance is suitable for small quantities only! Fill
containers with the maximum quantities only as indicated
in the table!
Assembly of Accessories
NOTE:
• The dough hook with the ring marking on its shaft must
only be attached to the right (larger) fitting of the mixer.
The other dough hook is intended for the left fitting.
• It does not matter which beater is inserted into which
opening.
1. Make sure the switch is at the "0" position and the appli-
ance disconnected from the mains.
Table
Product / method of preparation
Heavy dough (e. g. yeast dough)
Cake batter or light crêpes mixture
Sponge mixture, waffle mixture, cream
Operation
1. Place the container with the ingredients on a flat surface.
2. Make sure the switch is at the "0" position and the appli-
ance disconnected from the mains.
3. Attach all accessories.
4. Connect the appliance to a properly installed earthed
socket.
5. Insert the dough hooks or beaters into the food to be
mixed. Set the desired speed with the speed switch.
HM3775_IM
2. Press the ends of the dough hooks or the beaters into
the openings provided in the mixer until they snap into
place. Slightly turning the accessories might help facili-
tate the process of attaching.
Releasing the Dough Hooks / Beaters
Press the release button to release the accessories.
NOTE:
The accessory can only be ejected when the speed
switch is in the "0" position.
Electric Connection
1. Make sure the switch is at the "0" position.
2. Before you plug the mains plug into the outlet, check
whether the system voltage that you want to use,
matches the one of the appliance. You will find informa-
tion about it on the type plate.
3. Connect the appliance to a correctly installed grounded
outlet.
Turning On / Off
• In order to switch on the appliance, set the switch to one
of the positions from "1" to "5".
• When at the "0" position, the appliance is switched off.
Speed Settings
Switch position 1 = lowest speed setting
Switch position 5 = highest speed setting (TURBO)
All speed settings allow you to temporarily switch to the
highest speed setting. In order to do so, press the TURBO
button during operation.
Please choose the accessories and speed setting according
to the table below:
Max. quantity Accessories
500 g Dough hooks
750 g Beaters
750 g Beaters
Begin at a low speed (level 1 – 2) and then increase this
if necessary.
6. Tilt the appliance slightly up and down.
7. Always turn the appliance off before removing it from
the vessel.
Ending Operation
1. Set the switch to "0" position and wait until the motor has
come to a complete stop.
2. Disconnect the plug from the outlet.
Speed setting Max. operating time
1 – 4 3 minutes
2 – 5 (or TURBO) 3 minutes
2 – 5 (or TURBO) 3 minutes
15.06.21
27