Publicité
Les langues disponibles
Les langues disponibles
ULTRAFLEX
4
Screw the nuts completely on the corresponding
90° unions (3), Fit and screw the unions manually as
indicated in the picture until they are inserted
completely. Turn them until they are positioned
correctly with respect to the pipes by unscrewing them
no more than one revolution, then tighten the nuts
with a 11/16" Allen wrench with a torque of 17,6 Nm
(13 lb ft) until the washer touches the nut.
WARNING
DO NOT USE teflon tape or adhesive tape.
DO NOT PUT any thread sealant like Loctite 542 or
similar products.
ONLY IN CASE OF ADDITIONAL STATIONS
5
FITTING APPLICATION FOR ADDITIONAL STATIONS
Position 3/8" straight unions (6) on the pumps as
indicated in the picture.
Put some fitting sealant type Loctite 542 or Loctite 545
on the thread. Fit and screw manually the fittings (6)
until they are completely inserted; then tighten them
with a 7/16" open end wrench with a torque of 17.6
Nm (156 lb ft).
WARNING
Do not use teflon tape or adhesive tape. Pay attention
to the sealant positioning: if it is inserted into the
system, it could block it and make it unusable.
6 Fix the pump to the bracket (3) supplied with
tilt X70 by using the 3 M8 screws (7) supplied
with tilt X70 according to the instructions enclosed
to tilt X70.
WARNING
Install the pump by positioning the filling hole
(8) towards the top (see the picture) for the right
pump operation and to allow filling and purging
the system completely (see par. 3.7).
Installation and Maintenance Manual
System fitting
5
Connection for additional
station
System fitting
6
Connection for additional
station
3
7
PUMP FOR HYDRAULIC SYSTEMS
Connection for
additional station
System fitting
5
Connection for additional station
System fitting
8
page 17
-
of 82
Publicité
