Publicité
Les langues disponibles
Les langues disponibles
ULTRAFLEX
6 Position the pump (2) on the dashboard front
side (6) interposing the gasket (7) and fix it by
inserting the 4 washers (8) and by tightening
the 4 self-locking nuts (9) with a 10 mm wrench
and a torque of 10 Nm (7,4 lb ft).
CAUTION
If the self-locking nuts are disassembled (9), they
must be replaced. (Contact our assistance
service, see page 6).
WARNING
Install the pump by positioning the filling hole
(10) towards the top (see the picture) for the right
pump operation and to allow filling and purging
the system completely (see par. 3.7).
7
Position the steering wheel supplied
separately (11) on the pump shaft (12) by using
the suitable key (13). Insert the washer (14) and
tighten the self-locking nut (15) with a 19 mm open
end wrench and with a torque of 40 Nm (29,5 lb ft);
then grease the thread by using some anti-seize
®
grease MOLYKOTE
1000 or a similar one.
CAUTION
If the self-locking nut (15) is disassembled, it must
be replaced. (Contact our assistance service, see
page 6).
Installation and Maintenance Manual
6
10
2
13
11
14
15
PUMP FOR HYDRAULIC SYSTEMS
9
8
9
8
9
8
9
8
7
12
page 15
-
of 82
Publicité
