Publicité
Les langues disponibles
Les langues disponibles
PARTS N EEDED:
• Six#8x3"(7.6 cm) w ood s crews (longer screws may beneeded)
• One ortwo2"x4"x32"(5cmx10cmx81cm) w ood board(s)
• Order factory p anels, make custom panels o rconsult a
qualified c abinetmaker
orcarpenter tomake thepanels.
Classic S eries: Order factory p anels, make custom panels, or
consult aqualified c abinetmaker
orcarpenter tomake the
panels. See "Installation Requirements"
formore information.
Overlay Series: Make custom panels, orconsult aqualified
cabinetmaker
orcarpenter tomake thepanels. See
"Installation Requirements"
formore information.
Architect ® Series i sshipped c omplete.
• Ifyouareconnecting thewater l ine directly t ocopper tubing
andnottoashutoff valve, youneed aferrule, aunion, anda
1/4" compression
fitting.
The refrigerator
canberecessed inanopening b etween cabinets
orinstalled attheend ofacabinet runusing a side panel to
enclose therefrigerator.
Overlay Series (42" [106.7 cm]Models)
Features factory-installed,
overlay style trim, t oprovide a
"frameless" look. T his series r equires theinstallation ofcustom
panels, handles, andstandoffs.
KBFO42FTX
INSTALLATION
REQUIREMENTS
IMPORTANT:
•
Installer: Leave Installation Instructions with the homeowner.
•
Homeowner:
Keep Installation Instructions for future
reference. Save these Installation Instructions for the local
electrical inspector's use.
TOOLS NEEDED:
Gather the required tools and parts before starting installation.
Read and follow the instructions
provided with any tools listed
here.
•
Hand drill or electric drill
•
Torx ®tT15 and T27
(properly grounded)
screwdrivers
•
Drill bits
•
rl/32" nut driver
•
Two adjustable wrenches
•
%", r/4", and r/2" open-end
wrenches
•
Phillips screwdriver
•
%2" Allen wrench
•
Small level
•
%" and %6" socket drivers
•
Appliance dolly
•
Tape measure
•
Utility knife
E×pmoeion Hazard
Keep flammable
materials
and vapors, such as
gasoUne, away from refrigerator.
Faimure to do so can reeuJt in death, e×pioeion,
or fire.
IMPORTANT:
•
Observe all governing codes and ordinances.
•
It is recommended
that you do not install the refrigerator
near an oven, radiator, or other heat source.
•
Do not install in a location where the temperature will fall
below 55°F (13°C).
•
Floor must support the refrigerator weight, more than
600 Ibs (272 kg), door panels and contents of the
refrigerator.
•
Ceiling height must allow for side tipping radius. See
"Tipping Radius."
•
Location should permit door to open fully. See "Door
Swing Dimensions."
•
Location must permit top grille removal. See "Opening
Dimensions."
1-®TORX is a registered trademark
of Textron Innovations
Inc.
Publicité
