Publicité
Les langues disponibles
Les langues disponibles
Door Swing Adjustment
36" (91.4 cm) Models
1. Check that the refrigerator door can open freely. If the door
opens too wide, remove the door stop screw from the bottom
hinge with a Torx ®tT15 screwdriver.
3. Push the top grille straight up; then pull straight out. Lay the
grille on a soft surface.
B
2=
3.
A
A. Door stop screw
Hold the door open to a position that is less than 90 °.
Replace the door stop screw in the bottom hinge and tighten.
IMPORTANT:
Do not place the door stop screw in the 130 °
position on Overlay Series models. See "Handle and Door
Clearances."
A
B
C
A. 130 °
B. 110° (Overlayseries)
C. 90 °
42" (106.7 cm) Models
1. Check that the refrigerator door can open freely. If the door
opens too wide, you will have to adjust the door stop
position.
2. Grasp both ends of the top grille.
A. Top grille
B. Cabinet side trims
4. The door stop is located on the top hinge.
A. Door stop screw "A"
B. Door stop screw "B"
C. Door s top
5=
Remove the 2 door stop screws.
•
To remove the outer screw ("A"):
With the door closed, firmly press the L-shaped bracket
towards the center of the refrigerator until the screw is
exposed.
•
To remove the inner screw ("B"):
Open the door 90 ° and the L-shaped bracket will expose
the screw.
@
A. Door stop screw "A"
B. Door stop screw "B"
1-®TORX is a registered trademark
of Textron Innovations
Inc.
26
Publicité
