Publicité
Les langues disponibles
Les langues disponibles
Levixo 30-50 RTS
For optimum reception, the aerial must not be cut and must be
as far away as possible from the power supply terminal blocks
and wires. The aerial must always be installed at a height and
must be visible from a distance.
Secure the aerial to the housing by inserting the
insulating shim between the housing and the base
of the aerial.
Cut the coaxial cable if it is too long. Shortening the cable will
improve the signal (a coaxial cable which is too long, extended
or connected with an insulating screw joint will distort the
signal).
The mounting plate is an active component of the aerial. It
4.8.3. Connection to the power supply
To connect the motor to the power supply, use a standard,
multicore cable with a minimum cross section of .3 x 1.5 mm².
5. COMMISSIONING
Ensure that the boom is correctly balanced before commissioning (see paragraph 4.7. "Balancing the boom")
5.1. Programming the remote
controls
To program a remote control:
[1]. Press the PROG button on the control unit
for 2 seconds. The red indicator will come on
permanently.
[2]. Press the radio control channel to be assigned to
the remote control is memorised.
If this procedure is carried out using a channel which
has already been memorised, this channel will be
cleared.
To add other remote controls:
repeat the above procedure.
To exit programming mode without programming a
remote control:
10
a
15 mm
b
2 s
[1]
5 mm
a
b
.......2 min........
[2]
Copyright © 2011 Somfy SAS. All rights reserved.
Publicité
