Publicité
Les langues disponibles
Les langues disponibles
Levixo 30-50 RTS
4.4. Mounting on the right (opposite of factory mounting)
The operation involves moving certain internal components as follows, in order to mount the barrier on the right:
Before performing any operations inside the housing, it is essential to ensure that the spring is released by
moving the boom to the vertical position.
Lock the boom by placing the key in the padlock closed position
- Slacken the spring tensioner
spanner until the bolt and nut
the housing can be removed.
- Remove the bracket
3
Ø19 spanner (with a tightening offset of at least 40 mm)
5
until the lever
begins to rotate.
- Pull and turn the lever
Note: Only one position is possible at 180°, and is
indicated by a notch.
Be sure not to damage the end limit contacts.
4
- Tighten the bolt
which immobilises the lever using a
torque wrench set to a torque of approximately 80 Nm.
- Place the unlocking key
position (padlock open
- Turn the boom support plate
hand.
- Lock the boom by placing the unlocking key
padlocked closed position
- Lock the spring tensioner
using the self-locking bolt and nut
Be sure to reposition the part
the spring tensioner and the spring.
- Adjust the spring tensioner
spring.
- In the control unit, reverse the black and brown wires of
the motor operating connections (terminals 3 and 5).
Copyright © 2011 Somfy SAS. All rights reserved.
1
completely using a Ø19
2
securing the base of
and loosen the bolt
4
using a
5
180°.
in the manual operation
6
)
90° anticlockwise by
7
in the
6
.
1
in the position (mark R)
2
.
8
located between
1
to lightly tighten the
.
1
L
R
2
5
180°
6
7
8
4
3
80Nm
4
90°
1
L
R
2
7
Publicité
