Publicité
Les langues disponibles
Les langues disponibles
When "on" is selected, the icon "
" will show on the screen. When temperature decrease is
detected, the appliance will enter anti-freeze mode (the screen shows 7℃ with "
" flashing).
When temperature increase more than 2° C, it will go back to previous working mode. You can
press any button to return to the previous working mode.
Child lock:
Press "OK" for 5 seconds until the screen shows "CC". The child lock is now activated. Repeat
same operation to deactivate the child lock function.
When child lock is activated, "CC" will flash 3 times and go back to temperature display. Press
any icon on the control panel, the screen will show "CC" 3 times and go back to temperature
display.
The child lock function will remain in function after resuming operation after a power failure.
Display Auto Off
Activate: press "-" & "OK" for 5 seconds. The screen will flash 3 times and activate the Display
Auto Off function. The display switches off if there is no operation within 30 seconds. Press any
icon to light the display on again.
Deactivate: repeat the same operation to deactivate this function.
When the Display Auto Off function is activated, press and hold "OK" & "-" simultaneously for over
5 seconds, during the process all icons on the display flash slowly, until all icons on the display go
off, the Display Auto Off mode will be deactivated.
Memory function
After power switches off, the heater memorizes the working set temperature before the power
failure and continues to work after power resumes. In the event of a power failure, the heater will
keep the internal clock running 24 hours. If the power is disconnected for more than 24 hours,
when the power is turned on again, the heater will return to the last used temperature, the internal
clock will return to the default time and start running again. The screen will flash, indicating that
there has been a power outage. The blinking state will continue until any button is pressed to
cancel the blinking.
Heating icon
1. When it is detected that the ambient temperature is lower than the set temperature and the
heater needs to start working, the heating icon will light up. If the ambient temperature is detected
to be higher than the set temperature, the heating icon will turn off.
2. In standby state, the heating icon is not displayed.
Reset
Press and hold "+" and " " at the same time for more than 5 seconds. The screen will show "rE".
The setting temperature will go back to factory default setting 21℃.
WiFi connection
Insert the power plug and turn on the power switch. Choose "OF" mode by pushing the
EN-15
Publicité
