Publicité
Les langues disponibles
Les langues disponibles
1st hour, the appliance will automatically move to the 2nd hour. Press "+" or "-" or "OK" to select
the working mode of the 2nd hour, and enter the next hour setting. Repeat above until you select
the working mode for the 24th hour (23 is displayed on the screen) setting. The heater will then
automatically go back to the setting interface of day of the week.
After you finish the setting the day, press "OK" to confirm and repeat same operation for rest of
the days.
After you finish the setting of P4, the display will flash for 30 seconds and then go back to the
setting menu with the display showing "Pr". "Pr" will then flash for 10 seconds, and then display
will go back to the working mode interface.
To check the whole program of P4, keep "+" & "-" pressed for 5 seconds when the display shows
"Pr". The screen will show the whole program hour by hour for each day of week.
Temperature calibration setting：
Press "+" or "-" to select "C". and Short press "OK" to enter C—temperature calibration setting
interface.
"0" will be shown on the display as default. Press "+" / "-" to set the compensation temperature
within ± 5℃.
Example: the temperature setting on your heater is 24° C. The heater stops heating even though
your thermometer says the temperature is only 22° C. In this case, choose the calibration value
-2° C.
Adjustment of screen brightness:
Press "+" or "-" to select LI. Press "OK" to enter LI—screen brightness setting interface. You can
adjust the brightness of the screen. The default setting value is 3.
Press "+" / "-" to choose from grade 1 to 5. Grade 1 is the darkest while 5 is the brightest.
Adaptive start function:
Press "+" or "-" to select "AS". Press "OK" to enter Adaptive Start setting interface. The screen will
show "on" or "oF". Press "+" or "-" to change the selection. When "on" is selected, the Adaptive
Start function is activated. When "oF" is selected, the function is deactivated. Default setting is
"OF".
This feature measures the thermal inertia of the room and turns on the heaters in advance to
ensure "comfort" temperature is reached at the set time. This function can turn on the appliance
for heating maximum 2 hours in advance.
Remarks: This function applies for P1, P2, P3 programs only.
Window detector function
Press "+" & "OK" for 5 seconds to enter the window detector setting with "
" flashing. The
display will show "on" or "oF". Press "+" or "-" to select. If "on" is selected, the window detector
function is activated. When "oF" is selected, the window detector function will be deactivated.
Press "OK" to save. After 5 seconds without operation, the heater will also automatically save the
setting and return to previous working mode. The default factory setting is off.
EN-14
Publicité
