Publicité
Les langues disponibles
Les langues disponibles
a great deal of dust, the circular saw should be connected to a
suitable dust extractor (observe you country's regulations regarding
wood dust extraction).
• For optimum dust extraction, connect the dust extraction port to a
suitable vacuum cleaner or work shop dust extraction system whiling
cutting wood.
• Wear a dust mask during cutting wood.
• Always wear ear hearing protection.
SERVICE&MAINTENANCE
Always disconnect the device before performing any adjustment or
maintenance operation. If the supply cord is damaged, it must be
replaced by the manufacturer or its service anent in order to avoid a
hazard.
Disconnect from the power supply immediately if the supply cord is
damaged.
Take care not to expose this tool to the rain.
If the carbon brushes need to be replaced, have this done by a
qualified repair person (always replace the two brushes at the same
time).
Store the tool and its accessories in a dry place and out of the reach of
children.
Regularly inspect the accessory, ensure the accessories are free of
crack and surface defects. Replace the accessory when it has worn
out.
Cleaning
Avoid using solvents when cleaning plastic parts. Most plastic parts
are susceptible to damage from various types of commercial solvents
and may be damaged by their use. Use clean clothes to remove dirt,
carbon dust, etc.
In particular clean the air vents after every use with a cloth and brush.
Remove stubborn dirt with high pressure air.
Free the guards from saw dust after each use.
Remove any dust that might block the guard.
Check the function of the lower guard, ensure it opens and closed
smoothly
Publicité
