Publicité
Les langues disponibles
Les langues disponibles
Applications
The hand-held circular saw is design for sawing straight cuts in wood,
in materials similar to wood, and in plastics.
Safety regulations
• Adjust the splitter so that is no more than 5mm from the tooth rim of
the saw blade and its lowest point is not retracted more than 5mm
relative to the tooth rim.
• Caution: Only use saw blades recommend by manufactures.(Only
Use diameter 185mm blade) Never use any abrasive wheels!
• Do not use cracked or misshapen saw blades.
• Do not use saw blades made of high-afloy, high speed steel (HSS).
• Never use saw blades which do not conform with the specifications
quoted in these instructions.
• Make sure that all the moving parts of the blade guard
• Work property without jamming.
• Make sure that all devices which play a role in covering the saw
blade are in proper working order.
• Warning: Never use the product if the upper guard is cracked or
damaged. Never use the product if the lower guard is not operating
property. Carefully check the lower guard before each use. If the
lower guard does not close or moves freely, have it checked and
repaired by a qualified specialist before using this product.
• The splitter must be properly adjusted and used at all times except
for plunge-cuts.
• Do not use the saw near fumes or combustible liquids.
• Use only sharp blades and suitable accessories.
• Always pull the plug out of the socket before converting, cleaning or
adjusting the saw.
• Keep the power cable sate from damage. Oil and acid can cause
damage to the cable.
• Never use saw blades with plates that are thicker or with sets that
are smaller than the thickness of the splitter.
• Never remove the plug from the socket by pulling on the power
cable and do not carry the saw by its cable. Have repairs carried out
only by specialists.
• If you use a cable reel, the complete cable must be drawn off the
reel, The conductor must have a minimum cross section of 1.5mm
• Secure all workpieces sufficiently and do not overload the machine.
• Wear suitable clothing and goggles and use a dust mask on dusty jobs.
• Wear ear muffs to protect your ears!
• For lengthy jobs on wood and when cutting materials which produce
2
.
Publicité
