Spanset RS 500 Notice D'utilisation page 20

for the slinging method "straight pull" is given. Mode factors (M) for
other slinging methods can be found in these instructions, amongst other
sources
I II
– Consider the geometry and surface condition of the load.
Common slinging methods for a SpanSet round sling (does not
I
apply to multi-leg-slings):
pull,
1.
straight tied,
2.
simply placed without tilt angle,
3.
simply placed with tilt angle.
4.
Common slinging methods for the use of SpanSet round slings in
II
pairs (does not apply to multi-leg-slings):
pull,
1.
tied.
2.
#
Danger! Death or serious injury due to falling loads when sev-
eral different SpanSet round slings or multi-leg-slings are used.
Use identical SpanSet round slings or multi-leg-slings.
#
Danger! Death or serious injury due to loads falling from
inclined positions. Use SpanSet round slings or multi-leg-slings
at the same extension.
4.4.2 Determining nominal load capacity
The nominal load capacity is influenced by the slinging method (see
4.4.1 Choosing SpanSet round slings and multi-leg-slings)
– The nominal load capacity must be greater than or equal to the mass of
the load.
– The actual effective load capacity is influenced by the slinging method
and the tilt angle at which the lifting procedure is to be carried out.
– To ensure SpanSet round slings or multi-leg-slings can take a flat,
wide cross section, there must be a support of a sufficient width at
both the crane hook and the load.
b
(see cover).
III IV
18