ETNA A3415 Notice D'utilisation page 27

Programming the duration and automatic stop
1 Press the MODE button until the indicator next
to the symbol begins to flash.
2 Select the length of the cooking time by
pressing the "+" or "-" button.
3 Subsequently, the indicator that was flashing
will remain lit.
4 Press the MODE button again until the
indicator above the symbol
5 Select the time that the cooking has to end by
pressing the "+" or "-" button.
6 Subsequently, the indicator that was flashing
will remain lit.
7 Select a function and cooking temperature.
8 The oven will remain switched off. The
indicators next to the
Your oven is programmed.
9 When the programmed time is reached, the
oven will switch itself on and will continue
cooking during the programmed time.
10 When the programmed finishing time is
reached, the oven will switch off, an alarm will
sound and the light next to the symbol
begin to flash.
11 Press any button to switch off the alarm and
the oven will switch on again.
12 Set the selectors to the position '0' to switch
off the oven.
begins to flash.
and symbols lit.
will
Caution
Pressing the MODE button, the display on the
screen will show any function programmed. It can
be changed by pressing the '+' or '-' button. By
selecting the desired function, the indicator next
to the corresponding signal will light.
In the event of a power cut, all the programming
of the electronic clock will be erased. If you
connect the oven again, you will notice that
'12:00' appears in the display. The correct time
has to be set.
Switching off the time of day
To switch off the time of day, press two buttons
at the same time and, after several seconds the
screen of your clock will go out. To switch on the
time of day, press any button and the current time
will appear again.
This function can only be used when the clock
shows the current time and there is no function
programmed (no function symbol is lit). Press any
button to switch on the time of day again.