Publicité
Les langues disponibles
Les langues disponibles
9. Operation
9.1. Battery Operation
•
When the BMS is in a dormant state, press the power button for 3 to 6 seconds
and the panel will activate. The LED indicators will turn on for 0.5 seconds from
"RUN".
•
Once the BMS is activated, press the power button for 3 to 6 seconds again to
put the board in a dormant state again.
•
When the BMS is activated, press the power button for 6 to 10s. When you
release it, the board will be reset and all the LEDs will light up for 1.5s at the
same time.
9.2. DIP Switch
When ARX batteries are used in parallel, different ones can be
distinguished by setting the address through the DIP switch on
the BMS. It is necessary to avoid setting the same address. For
the definition of the BMS DIP switch, refer to the table below.
IMPORTANT!
•
To obtain the latest update of the ARX manual, please follow the link bellow.
29
Publicité
