Sony VPL-FX52L Manuel D'installation page 11

6
By using a Phillips screwdriver, remove the four
screws (M4 × 12, with washers) as shown in the
illustration below.
7
Remove the lens by lifting it slightly, widening the
lens cushion and sliding it forward.
8
Pull out the optical block protector in the direction
of the arrow.
9
Widen the lens cushion and install the lens so that
the lens stopper and the projector stopper meet at
their edges.
Downloaded from: https://www.usersmanualguide.com/
Optical block
protector
Stopper (Projector)
Stopper (Lens)
Notes
• Be sure not to catch the connectors when
installing the lens.
• For ease of identification when you install the
lens, make sure that the label on the lens is facing
up.
10
Tighten the four screws to secure the replacement
lens firmly.
11
Connect the two connectors.
Skip this step and the next when installing a lens
other than the standard one.
12
Fasten the connector cables you released in step 4
with the cable binder.
13
Install the lens cover by sliding it from front to
back.
14
Tighten the two screws to secure the lens cover
firmly.
Notes
• The lens scratches easily, so when handling it,
always place it gently on a stable and level surface in
a horizontal position.
• Avoid touching the lens surface.
Lens cover
11