Publicité
Les langues disponibles
Les langues disponibles
FUNCTIONAL DESCRIPTION
1
15
14
13
12
11
17
1. Protective foam top
bumper
2. Laser aperture
window
3. Protective foam
handles
4. ON/OFF button
5. Sweep button
6. Pair indicator LED
7. Pair button
8. Bump alarm
indicator LED
9. Plumb dot aperture
window
2
3
10. X/Y Iron sights
11. Short lanyard
attachment handles
12. ONE-KEY™ indicator
LED
13. Leveling mode button
14. Leveling mode
indicator LED
15. Leveling mode button
16. 5/8"-11 mounting insert
(2)
17. ONE-KEY™ coin cell
compartment
WARNING
cific charging instructions, read the operator's
manual supplied with your charger and battery.
4
Removing/Inserting the Battery
To remove the battery, push in the release buttons
5
and pull the battery pack away from the tool.
WARNING
6
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
7
WARNING
8
may be hazardous.
To reduce the risk of injury or damage, securely
9
mount/attach the laser before starting an opera-
tion. Injury/damage may occur if the laser falls.
Mounting the Rotary Laser
The rotary laser can be mounted to a
tripod or Rotary Laser Wall Mount:
• If working overhead, ensure the
10
laser is secure before operating
and attached to a MILWAUKEE
35 lbs rated lanyard.
• Ensure the laser and accessories
are on a stable surface.
• Use one of the 5/8"-11 threaded inserts to mount on
a tripod or Rotary Laser Wall Mount.
Lanyard Attachments
Use MILWAUKEE Lanyards to
help reduce the risks associated
with dropped tools. Complies
with ANSI/ISEA 121:2018.
1. Follow instructions provided
with tool lanyard.
2. When using the lanyard,
user must attach both short
handles together properly, as shown above, before
operation.
WARNING! To reduce the risk of serious injury or
16
death, use only lanyards rated for the weight of
the tool.
The rotary laser can operate in horizontal and
vertical plane orientations. When in Auto-Leveling
Mode, the laser will adjust to create a level or plumb
plane, respectively. When placed in vertical orienta-
tion, the laser will default to a plumb point mode
for setup. To project a vertical line, press the Rota-
tional Speed button until desired RPM is achieved.
NOTE: The laser will only work in one specific vertical
orientation, with the keypad facing up and parallel to
the working surface. Other orientations will result in
a leveling error.
4
ASSEMBLY
Recharge only with the charger
specified for the battery. For spe-
Always remove the battery pack
any time the tool is not in use.
Only use accessories specifically
recommended for this tool. Others
Laser Orientation
Publicité
