Publicité
Les langues disponibles
Les langues disponibles
Federal Communications Commission
WARNING
proved by the party responsible for compliance could
void the user's authority to operate the equipment.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful in-
terference in a residential installation. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance
with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or televi-
sion reception, which can be determined by turning
the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
SYMBOLOGY
Changes or modifications to
this unit not expressly ap-
Volts
Direct Current
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
Read Operator's Manual
Power Button
RPM Button
Sweep Button
Leveling Button
Pairing Button
Bump Alarm LED
Y-Axis Indicator
Coin Cell Polarity Indicator
SPECIFICATIONS
Cat. No. ..................................................... 3702-20
Volts.............................................................. 18 DC
Battery Type .................................................M18™
Charger Type................................................M18™
Module/FCC ID ............................ BGM11S/QOQ11
Coin Cell Battery Type ............................... CR2023
Laser............................................................Class 2
Max Power.......................................... P
Wavelength........................................ 510 - 530 nm
Beam Divergence ................................... <1.5 mrad
Rotational Speed ....................300, 600, 1200 RPM
Sweep Angles ................................0°, 10°, 45°, 90°
Single Slope Axis Range ..........................±6° (min)
Leveling Range......................... 12° in X and Y Axis
Working Range .............................1000' (Diameter)
Horizontal Plane Accuracy..... ±1/16" at 100' (0° tilt)
Vertical Plane Accuracy ........... ±1/8" at 100' (0° tilt)
Plumb Point Accuracy.............. ±1/8" at 100' (0° tilt)
Altitude..........................................................<6560'
Pollution Degree .................................................. 2°
Typical Leveling Time ...................... <12 (Seconds)
Travel Startup Time @ 8° ................ <40 (Seconds)
Mounting Insert ............................................ 5/8"-11
Ingress Protection (Tool Only) ......................... IP66
Drop ................................................................1.5 m
Tip Rating ..........................................................2 m
Bare Tool Weight .............................................8 lbs
Weight .............................................................9 lbs
(With M18 XC™ 3.0 battery pack)
Maximum Relative Humidity (RH) ..................... 80%
Decreasing Linearly Relative Humidity (RH) ..... 50%
Recommended Ambient
Storage Temperature..................... -13°F to 140°F
Operating Temperature .....................0°F to 122°F
Recommended Compatible
Remote/Receiver Cat. No. ......................... 3712
NOTE: Accuracies and leveling times are measured
on a level surface at ambient temperatures. Use of
the tool in extreme conditions may negatively impact
these specs.
3
BL654/SQGBL654
≤ 1 mW
AVG
(With Remote/Receiver)
for up to 88°F
at 104°F
Publicité
