AC Infinity AIRTITAN Serie Manuel D'utilisation page 35

PROGRAMMING
T-SERIES
VPD MODE (HIGH VPD TRIGGER)
Pressing the up or down button sets the high VPD
trigger. The devices will activate if the probe's reading
meets or exceeds this threshold.
Once triggered, the devices will gradually ramp up to
the level set in ON mode. If the probe's reading falls
below this trigger point, the devices will gradually slow
down to a stop or at the level set in OFF mode.
You may set this trigger below the low VPD trigger to create a specific range in which the devices
are active.
Either of the two trigger points can activate while you are in VPD Mode, even if you are viewing another trigger point.
Set a trigger point to OFF if not in use, by holding down the up and down button. If there is a level set in OFF Mode
other than zero the devices will run at that level when triggered to turn off.
HIGH VPD
TRIGGER POINT
1.1kPa
OFF
0
kPa
LOW VPD
ON
9.9
kPa
HIGH VPD
35