KitchenAid KSSC36FMS Guide D'utilisation Et D'entretien page 13

Ice and cold water dispensers
models KSSC36PI, KSSC42H, KSSC48H)
Cut Hazard
Use a sturdy glass when dispensing ice or water,
Failure to do so can result in cuts.
ice dispenser
Ice dispenses from ice maker storage bin in the freezer.
When dispenser bar is pressed, a trap door opens in a
chute between the dispenser and ice bin. Ice moves from
the bin and falls through the chute. When dispenser bar is
released, a buzzing sound may be heard for a few
seconds.
Your refrigerator dispenses both cubed and crushed ice.
Before dispensing ice, select which type of ice you prefer.
For cubed ice, move Ice Selector Switch left to the
"Cubed" position. For crushed ice, move Ice Selector
Switch right to the "Crushed" position.
To dispense ice:
1. Move Ice Selector Switch to desired setting.
2, Press a sturdy glass against the ice dispenser bar.
Hold glass close to dispenser opening so ice does not
fall outside of glass.
3, Remove the glass to stop dispensing.
Water dispenser
IMPORTANT: If the water dispenser stops working, water
may be frozen in the water line leading to the dispenser. If
this happens, turn the FreshChill* Meat Locker
Temperature Control toward "Cold."
Chilled water comes from a 50 oz. (1.5 L) tank behind the
crispers. Allow about 24 hours to chill the first tankful of
water.
When the refrigerator is first hooked up, press the
water dispenser bar until you draw and discard 2 to 3
quarts (1.9 to 2.9 L) of water. This removes air from the
system and rinses the water filter, tank, and pipes. Ice
maker will not produce ice without filling tank.
If the dispenser is not used regularly, dispense enough
water every week to freshen the supply. Allow two to three
hours for a new supply of water to chill.
IMPORTANT: The small tray under the dispenser is
designed to evaporate small spills. There is no drain in
the tray. Do not pour water into it.
To dispense water:
1, Press a sturdy glass against the water dispenser bar.
2, Remove glass to stop dispensing.
13