Publicité
Les langues disponibles
Les langues disponibles
.. Water connection
NOTICE!
Damage to the appliance!
If the appliance is connected improperly, there is a risk
of damage to the appliance.
The hose must be free of kinks and connected care-
fully.
If the water pipes are new or have not been used for
a long time, run the water to ensure that the water
is clear and free of impurities. If this precaution is
not taken, there is a risk of the water inlet becoming
blocked and the appliance being damaged.
When connecting to the drinking water, ensure that the appliance is
connected to a safety device to stop the drinking water becoming con-
taminated by backflow (in accordance with DIN EN 1717). We recommend
hiring a qualified specialist to perform the installation work, including
the water and electrical connections, and any repair work.
If the hose supplied does not fit your tap, you can buy adapters from
your plumbing supply store.
Connect the water supply hose to the connection for the
water supply (13). Screw the hose connection hand tight.
Connect the end of the hose with AquaStop to a cold wa-
ter tap with a 3/4" thread (see Fig. 5). You can also connect
the supply hose to a hot water tap if the water tempera-
ture does not exceed 60°C.
This reduces wash time by about 15 minutes.
Screw the hose connection hand tight.
The water hose is designed for a water pressure of approx. 10
bar. We recommend turning off the water supply after use,
especially if your house connection does not have a pressure reducer.
.. Connecting the water outlet
You can connect the outlet hose in different ways:
– connect the hose to a special connection on the drain pipe
– feed the hose into a drain pipe.
DE
FR
NL
ES
IT
EN
Fig. 5
145
Publicité
