Wash Fitting Settings - Franke ZAQUA091 Notice De Montage Et De Mise En Service

Adjusting the extension of the flow duration/flushing time
8.5 Use the + and – (
steps.
• The LED in the sensor of the fitting flashes:
– 4 × short for each adjustment by one step
– 2 x long when the respective end setting is reached
Switching off the fitting
8.6 Press the
• The fitting is now permanently closed.
• The LED in the sensor of the fitting flashes:
– 3 × short, break, 3 × short, break, ...
8.7 Press the
• The fitting is ready for operation.
9.

Wash Fitting Settings

Setting for continuous flow
For continuous flow, a time of 3.5 min or 11 min can be set (default 3.5 min).
9.1 Press the TEST key.
9.2 Press the
• The time for the continual flow is set.
• The LED in the sensor of the fitting flashes:
– 2 × long = 11 min continual flow time
– 4 × short = 3.5 min continual flow time
9.3 Exit the adjustment mode.
• Press the TEST key.
or
• Wait 60 seconds.
☞
This function is not available for products manufactured before 1 June 2003. Press
the corresponding buttons to switch the fitting off.
6
) keys to adjust the extension of the flow duration in individual
OFF key.
OFF key again.
OFF key repeatedly until the required mode has been set.