Franke ZAQUA091 Notice De Montage Et De Mise En Service page 20

Safety time-window
Start delay
☞
By default, the parameter is set to code 1.
• The LED in the sensor of the fitting confirms the entered code
– LED flashes briefly = unit digit
– LED flashes long = tens digit
Stopping thermal disinfection
11.22 Press the
• The LED in the sensor flashes with 1s intervals
• If the fitting is in the exposure phase, the cooling phase starts immediately.
• If the fitting is in the cooling phase, the solenoid valves are closed immediately.
Thermal disinfection emergency-stop
11.23 Press key
• The LED in the sensor does not flash.
Exiting from TD Mode
11.24 Press and hold the RESET key.
11.25 Additionally press the
• The LED flashes 4 × briefly.
or
if thermal disinfection is being performed, wait for the end of the disinfection process.
Resetting default factory settings (Reset)
11.26 Press the RESET key for at least 3 s.
• The system now has the factory settings again.
• The LED flashes briefly 4 × short (2 × in succession).
20
10 sec
30 sec
1 min
2 min
3 min
OFF key.
OFF 2 times.
OFF key within 2s.
0 h 0.5 h
1 6
2 7
3 8
4 9
5 10
1 h 2 h
11 16
12 17
13 18
14 19
15 20
4 h
21
22
23
24
25