Hilti NURON AG 5D-22 Mode D'emploi page 41

5.2 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions have been measured in accordance with
a standardized test and may be used to compare one power tool with another. They may be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the power tool is switched
off, or when it is running but not actually being used for a job. This can significantly reduce exposure over
the total working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: Maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Grinding thin sheet metal or other large-area structures prone to vibration can lead to increased noise
emissions higher than the stated noise emission values. You can reduce the noise emissions produced in
this way by adopting noise-reducing measures such as the application of heavy, flexible insulating mats.
Always take these increased values into consideration as well in the hazard assessment of noise exposure
and in the choice of suitable hearing protection.
Noise information
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Sound power level (L
WA
Uncertainty for the sound power level (K
Vibration information
Other applications, such as cutting, may produce vibration values that deviate from the given values.
Surface grinding with the vibration-absorbing side handle
(a )
h,AG
Sanding with sandpaper with the vibration-absorbing side
handle (a )
h,DS
Uncertainty (K)
6 Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 29
6.2 Inserting the battery
WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
*2272031*
)
pA
)
pA
)
)
WA
2272031
88 dB(A)
3 dB(A)
96 dB(A)
3 dB(A)
AG 5D-22
B 22­55 5.4 m/s²
B 22­170 4.6 m/s²
B 22­55 3.5 m/s²
B 22­170 3.8 m/s²
1.5 m/s²
English 33