Publicité
Les langues disponibles
Les langues disponibles
▶ If the battery is too hot to touch, it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Consult Hilti Service or read the
document entitled "Instructions on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
→ page 38
Read the instructions on safety and use of Hilti Li-ion batteries that you can access by scanning
the QR code at the end of these operating instructions.
3
Description
3.1
Product overview
3.2
Intended use
The product described is a hand-held cordless angle grinder. It is designed for cutting and grinding metal
and mineral materials, brushing, sanding and for hole cutting in tiles, all without use of water.
The tool can be used for cutting, slitting and grinding mineral materials only in combination with the
appropriate guard.
A dust removal hood together with a suitable Hilti vacuum cleaner must be used for working on mineral
materials such as concrete or stone.
•
For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum performance,
Hilti recommends the batteries stated in the table at the end of these operating instructions for this
product.
For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
•
operating instructions.
3.3
Items supplied
Angle grinder, side handle, standard guard, front cover, clamping flange, clamping nut, pin wrench, operating
instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
*2272031*
1
2272031
Guard release button
@
Spindle lock button
;
Battery status indicator
=
Battery release button
%
Battery
&
Spark guard
(
Air vents
)
Vibration-absorbing side handle
+
Gripping surface
§
Switch-on interlock
/
On/off switch
:
Threaded bushing for the grip
∙
Spindle
$
Standard guard with front cover
£
Clamping flange with O-ring
|
Abrasive cut-off wheel / abrasive grinding
¡
wheel
Kwik lock clamping nut (optional)
Q
Clamping nut
W
Pin wrench
E
English
29
Publicité
