Sanding Cuts And Sandpaper - Clarke American Sanders Super 7R Edger Manuel De L'utilisateur

ENGLISH
EN

SANDING CUTS AND SANDPAPER

Initial Cut
The purpose of the initial cut is to remove old finish and gross imperfections on the floor surface. A coarse abrasive should be used.
If glazing, loading, or burning takes place immediately into an initial cut, select a coarser abrasive. If this should occur during an initial
cut, the abrasive has dulled and must be replaced.
Final Cuts
The purpose of a finishing cut is to remove the scratches produced during the initial cut. Use a fine (60 - 80 grit) grain abrasive.
If the surface remains rough after a finishing cut, it may be necessary to use an even finer grain of abrasive (80 - 100 grit). Care
should be taken in selecting the grit size of the abrasive. A very fine grain will close the pores on a wood floor making admission of a
stain difficult.
Clarke
® American Sanders Operator's Manual (EN) - Super 7R - 7 -