Electrolux IK2080SR Notice D'utilisation page 8

3.2 Switching on/off
Switching on
1. Connect the mains plug to the power
socket.
2. Press ON/OFF if the display is off. The
temperature indicators show the set
default temperature.
If "dEMo" appears on the display, refer to
"Troubleshooting" .
Switching off
1. Press ON/OFF for 3 sec.
The display switches off.
2. Disconnect the mains plug from the
power socket.
3.3 Temperature regulation
Press the temperature regulators to set the
temperature of the appliance.
The temperature range may vary between
2°C and 8°C for fridge (recommended 4°C).
The temperature indicators show the set
temperature.
The set temperature will be reached
within 24 h.
After a power failure the set temperature
remains stored.
3.4 FastCool function
FastCool function allows to chill large amount
of warm food rapidly to avoid warming food
already stored in the fridge.
1. Press the Mode until the corresponding
icon appears.
The FastCool indicator flashes.
2. Press the OK to confirm.
The FastCool indicator appears.
This function stops automatically after
approx. 6 hour.
To deactivate the function before it
automatically ends, repeat the procedure or
select a different fridge set temperature.
8 ENGLISH
3.5 FastFreeze function
The FastFreeze function is used to pre-freeze
and fast freeze in sequence in the freezer
compartment. This function accelerates the
freezing of fresh food and protects foodstuffs
already stored from warming.
To freeze fresh food activate the function
at least 24 h before placing the food to
complete pre-freezing.
1. Press Mode button until the FastFreeze
indicator blinks to activate this function.
2. Press the OK button to confirm.
The FastFreeze indicator lights up.
This function stops automatically after 52 h.
Repeat the procedure or select different
temperature to deactivate the function.
3.6 ChildLock function
Activate the ChildLock function to lock the
buttons from unintentional operation.
1. Press Mode until the corresponding icon
appears.
The ChildLock indicator flashes.
2. Press OK to confirm.
The ChildLock indicator is shown.
To deactivate the ChildLock function, repeat
the procedure until the ChildLock indicator
turns off.
3.7 DrinksChill function
The DrinksChill function sets an acoustic
alarm at the preferred time.
1. Press Mode until the DrinksChill indicator
blinks.
The Timer shows the set value (30 min) for a
few seconds.
2. Press the Timer regulator to change the
set value from 1 to 90 min.
3. Press OK to confirm.
The DrinksChill indicator lights up.
The Timer starts to blink (min).
At the end of the countdown the "0 min"
indicator blinks and the alarm sounds. Press
OK to switch off the sound and deactivate the
function.