Publicité
Les langues disponibles
Les langues disponibles
Problem
Surfaces inside the fridge compart‐
ment are warmer.
DEMO appears on the display.
or
or
appears instead of
numbers on the temperature dis‐
play.
If the problem persists, contact the
Authorised Service Centre.
7.2 Replacing the lamp
For replacing the lamp, contact the
Authorized Service Centre.
8. TECHNICAL DATA
The technical information is situated in the
rating plate on the internal side of the
appliance and on the energy label.
9. INFORMATION FOR TEST INSTITUTES
Installation and preparation of the appliance
for any EcoDesign verification shall be
compliant with EN 62552 (EU). Ventilation
requirements, recess dimensions and
minimum rear clearances shall be as stated
10.
GUARANTEE
CH
Customer Service Centres
Industriestrasse 10
5506 Mägenwil
Possible cause
The appliance is in the demo mode.
Temperature sensor problem.
7.3 Closing the door
1. Clean the door gaskets.
2. To adjust the door, refer to installation
3. To replace the defective door gaskets,
Voltage
Frequency
in this User Manual in "Installation". Please
contact the manufacturer for any other further
information, including loading plans.
Point of Service
1028 Préverenges
Solution
This is normal.
Press and hold the OK button for
approx. 10 sec until you hear a long
sound and the display turns off for a
short time.
Contact the Authorised Service
Centre. The cooling system will con‐
tinue to keep food cold, but temper‐
ature adjustment will not be possi‐
ble.
instructions.
contact the Authorized Service Centre.
Le Trési 6
230-240 V
50 Hz
Via Violino 11
6928 Manno
ENGLISH
15
Publicité
