Publicité
Les langues disponibles
Les langues disponibles
Programming the wireless remote control
Important:
• Only those heaters should be connected to the mains that are
to undergo programming to a hand-held transmitter key. This
allows the programming of several receivers (multi-power).
Previously programmed devices can remain connected to the
mains.
• Use of other components with a wireless-signal interface
(e.g. wireless PC mouse and keyboard) may result in faulty
operation of the wireless receiver. Switch off all other wireless
components, particularly when programming.
• For device type D2, the LED operating display supports pro-
gram progress:
LED A: Programming mode
LED B: Time switching
LED C: Wireless transmission blocked
• The wireless receiver is briefly disabled after command entry
using the hand-held transmitter.
The heater to be programmed is connected to the mains (LED
Initial
programming:
C flashes quickly). Brief pressing of the desired key 1 to 4 on
the hand-held transmitter triggers wireless receiver program-
ming, heating tube starts at low level (LED A flashes quickly).
Repeated pressing of the same key confirms the programming,
heating tube switches to top level (LED A flashes quickly).
If desired, time-out switching can be programmed by double-
clicking: If the programmed key is pressed briefly twice in suc-
cession, the heater will switch off in 30 minutes, the heating tube
activates for 2 seconds (LED B flashes quickly). Double-clicking
again increases the heating duration to 60 minutes, heating tube
illuminates for 4 seconds (LED B flashes at medium speed).
Double-clicking again increases the shut-down to 90 minutes,
heating tube illuminates for 6 seconds (LED B flashes slowly).
Double-clicking once more switches the time control off. The
programming cycle for time-out switching begins again from the
beginning.
Programming is ended by long pressing of the programmed key
of the hand-held transmitter. The heating tube confirms that pro-
gramming is completed by operating for two seconds (all three
LED's light up briefly).
Multiple
It is possible to program radiant heaters on up to eight keys on
one or more hand-held transmitters (multi-control).
programming:
Connect the relevant heaters to the mains. As described un-
der „Initial programming", the key to be programmed is briefly
pressed, heating tube starts at low level (LED A flashes quickly).
Repeatedly pressing ensures that the heating tube goes to full
level (LED A flashes quickly).
Then the next key is activated by brief pressing, the heating
105
Publicité
