solamagic IR05007-WSI Instructions De Montage Et D'utilisation page 104

Initial operation
Warning: Completely remove the transport protection on the reflector.
Make the connection to the power supply (Schuko/mains plug).
The tube has switched off, for device type D2 LED C flashes.
The wireless remote control must be programmed for operation, see the "Initial
programming" section.
C
B
A
Operating display: For D2 LEDs A, B, C
Wireless remote control
For the device to be operated, you need the SOLAMAGIC FUS6 wireless remote
control which can be purchased from your distributor.
Assign a key on the hand-held transmitter for heat regulation.
Key assignment:
Remote control:
Keys 1-4: Wireless channel keys
Transmission frequency: 433.92 MHz
Battery: CR 2032, 3 volt
Range: approx. 20 m with an unimpeded
path through air
104