SAKAWA AS9TG Manuel D'utilisation page 78

Danger of skin injection.
The high-pressure fluid can be injected under the skin, which can
lead to serious injury, including amputation.
-Make sure all fittings are tight before applying pressure. Relieve
pressure from the system before performing maintenance.
-Do not check for leaks by hand. Instead, use a piece of cardboard
to check for leaks.
-If an injection occurs in the skin, look for
"Surgical Treatment"
Troubleshooting
Problem
Cylinder rod does not move
Slow speed of the cylinder shaft when
extending or retracting
The wood will not split or will split very
slowly
Engine Gets Stuck During Splitting
Engine stalls under low load conditions
Cause
A-Insufficient oil to pump
B-Air in oil
C-Excessive Vacuum Pump Inlet
D-Blocked Hydraulic Lines
WARNING
SOLUTION: A, D, E, H, J
SOLUTION: A, B, C, H, I, K, L
SOLUTION: A, B, C, F, I, K
SOLUTION: G, L
SOLUTION: D, E, L, M
Solution
Check the oil level in the oil tank
Check the oil level in the oil tank
Check the pump inlet hose for blockages
or kinks
Rinse and clean the splitter hydraulics
78