Elcometer BALTIC 30 Manuel D'utilisation page 19

Pay adequate attention when handling the unit in order to prevent any damage that might lead to
dangerous situations for the user or personnel standing near the unit, as a consequence of leaks,
breakages, etc.
The equipment has been designed for use at room temperature. The maximum operating
o
temperature is 50 C.
The use of solvents and/or detergents that contain halogenated
hydrocarbons
cause chemical reactions in the unit as well as in its zinc-coated
components (trichloroethane mixed with small amounts of water
produces hydrochloric acid). For this reason, these components may
rust and in extreme cases the chemical reaction caused may be
explosive. We recommend you to use products that do not contain
the aforementioned components. Do not use acids, soda (alkalis or
pickling substances, etc.) for cleaning under any circumstances.
In general, precautions must be taken whenever the unit is handled, in order to prevent any damage
to this.
Connectors must be securely tightened and in good condition. If pneumatic connectors are fitted,
they must comply with the standard ISO 4414:2010.
Safety standards must be understood and applied.
Any non-compliance with the indications set out in this manual may lead to incidents affecting the
physical integrity of the user or other personnel or animals.
Respect and comply with indications relating to the conservation of the environment.
Always keep the safety sheets for the products to apply and the cleaning liquids to hand in case you
need to consult them.
14. Observations
By following the instructions set out in this manual you will ensure good spraying and quality of finish.
Should you have any doubt, please contact the Technical Service of ELCOMETER.
15. Warranty Conditions
This device has been manufactured with great precision and has been subjected to a large number
of controls before leaving the factory.
The WARRANTY is valid for 3 years, counted as of the date of purchase, which will be indicated by
the seller in the place provided for this purpose, together with his stamp. Once the unit has been
received, please complete the warranty and send this to the manufacturer for validation
This WARRANTY covers any manufacturing defect, which will be repaired without charge. However,
any malfunction resulting from the incorrect use of the unit, such as inadequate connections,
breakage due to dropping, or similar, the normal wear of components and in general any deficiency
not attributable to the manufacturer of the device, are expressly excluded. Likewise, the WARRANTY
shall be rendered null and void when it is evident that the unit has been handled by persons other
than our Technical Assistance Service.
This WARRANTY does not support any undertaking made by anyone outside our Technical
Service.
www.elcometer.com
(trichloroethane, methyl chloride, etc.), may
EN 17