Elcometer BALTIC 30 Manuel D'utilisation page 10

The Baltic 30 pump is characterised by its double regulator (pump and
gun), as it is a mixed pump (Air assited airless). This system uses air for
spraying. The "mixed" equipment projects the product at high pressure
through the spraygun assisted by air. This system consists of a pump, a
gun and two hoses (air and product).
In this case, the air-product ratio is as follows:
AIR 20% PRODUCT 80%
The choice of fluid hoses must been done according to the material
sprayed and the maximum pressure than the pump can deliver.
08. Instalation
INCORRECT INSTALLATION OF THE MACHINE MAY CAUSE DAMAGE
TO PEOPLE, ANIMALS OR OBJECTS. THE MANUFACTURER CANNOT BE
CONSIDERED RESPONSIBLE FOR THESE DAMAGES
08.1. Transport and discharge
The equipment is delivered packaged. It must be transported and stored according to the indications
on the packaging. Due to the low weight of the remover can be moved by two people without using
other means.
08.2. Arrangement of the lighting system
The Client must make sure that there is suitable lighting for the surroundings and that the lighting
conforms to the regulations in force. In particular, the Client must arrange the positioning of lighting
that illuminates all the working area.
08.3. Arrangement of the pneumatic system
The Client must arrange a line of filtered compressed air supplied by a compressor that is suitable for
the consumption required.
Do not use compressed air that contains chemical products, synthetic oil with organic solvents, salts
or corrosive gases as they can cause damage or malfunctioning.
The line of compressed air must arrive up to the supply points of the machine.
If the compressed air contains a large amount of moisture, it may cause malfunctioning in the valves
and in the pneumatic components. Install a moisture separator downstream from the compressor to
avoid this.
08.4. Classification according to the ATEX directive
The machine conforms to the essential requisites of the EU Directive 2014/34/UE, better known as
ATEX ("Explosive atmospheres"). It is classified as group II category 3 letter G system. The assessment
procedures of conformity, carried out by an internal factory check, allow the installation of the machine
in surroundings where there may be potentially explosive atmospheres due to the presence of gas,
fumes or mist.
EN 08
www.elcometer.com