Beurer SI 40 Mode D'emploi page 18

Problem/ Possible cause/remedy
question
The device is 1. Check that there is water in
switched on the container of the water
but produces heater tank.
no or hardly
2. Check that there is liquid in
any steam.
the aroma container.
3. Make sure that the suction
tube and other components
have been attached properly.
4. Check the nozzle for blo-
ckages. Clean the nozzle if
necessary (see "Cleaning
the nozzle" section in the
"Cleaning and disinfection"
chapter)
Does eve- Yes, this is absolutely essential
ryone need for hygiene reasons.
a separate
mask?
11. DISPOSAL
For environmental reasons, do not dispose of the
device in the household waste.
Please dispose of the device in accordance
with EC Directive – WEEE (Waste Electrical
and Electronic Equipment).
If you have any questions, please contact
the local authorities responsible for waste dispos-
al.
12. TECHNICAL SPECIFICA-
TIONS
Model
Dimensions
(Includes Facial
sauna mask)
(W x H x D)
Weight
SI 40
300 x 315 x 130 mm
738 g
Filling volume
of internal water
heater
Aroma container
filling volume
Mains connection
Steam temperature Approx. 43°C
Water boiling time
Maximum operati-
on time
Operating condi-
tions
Storage and trans-
portation condi-
tions
Subject to technical changes.
Please contact the specified service address to
obtain further information, such as the CE Declara-
tion of Conformity.
13. WARRANTY / SERVICE
Further information on the guarantee and guaran-
tee conditions can be found in the guarantee leaf-
let supplied.
18
Max. 25 ml
Max. 60 ml
220 – 240 V~; 50 – 60 Hz
Approx. 2 minutes
Approx. 10 minutes
Temperature:
+10°C to +40°C
Relative humidity:
10% to 95%
Ambient pressure:
700 hPa to 1060 hPa
Temperature: 0°C to +60°C
Relative humidity:
10% to 95%
Ambient pressure:
500 hPa to 1060 hPa