Craftsman CMXEVBE17250 Mode D'emploi page 8

INSTALLATION
Vac Assembly
1. To Attach the Powerhead Assembly (Fig. E):
Line up the Powerhead Assembly Latches to the
Notches located on each side of the Drum.
NOTE: Powerhead Assembly must be aligned with Drum
for proper attachment.
2. Place Powerhead Assembly on top of Drum.
3. Be sure Powerhead Assembly completely covers the
top of the Drum so leakage does not occur.
4. Press down on the Powerhead Assembly Latches to
securely attach the Powerhead Assembly to the Drum.
Fig. E
Powerhead
Assembly
Press Down
on Powerhead
Assembly
Latches to
Engage onto
Drum Tabs
Drum
Tabs (2)
Latches (2)
5. To Remove the Powerhead Assembly (Fig. F):
First unplug the unit from the electrical outlet.
Then pull out and lift up on the Powerhead Assembly
Latches to remove from Drum Tabs.
Fig. F
Powerhead
Assembly
Drum
Tabs (2)
Pull Out and Lift
Up on Powerhead
Assembly Latches
to Disengage the
Drum Tabs
SP7097-2 CMXEVBE172500.indb 7 SP7097-2 CMXEVBE172500.indb 7
Insert Hose
To Insert Hose Assembly into the Vac (Fig. G):
Insert the End of the Hose Assembly into the Vac Inlet.
Fig. G
To Remove the Hose Assembly from the Vac (Fig. H):
Twist and pull out on the Hose Assembly to release the
Hose from the Vac Inlet.
Fig. H
Latches (2)
Powerhead
Assembly
Vac Inlet
Port
Hose Assembly
Vac Inlet Port
TWIST & PULL
Hose Assembly
7
11/16/21 11:23 AM 11/16/21 11:23 AM