Publicité
Les langues disponibles
Les langues disponibles
Mounting
This type of cooker hood must be fixed to the ceiling.
Very heavy product; hood handling and installation must
be carried out by at least two persons.
Before beginning installation:
•
Check that the product purchased is of a suitable size for
the chosen installation area.
•
Remove the charcoal (*) filter/s if supplied (see also
relative paragraph). This/these is/are to be mounted only
if you want lo use the hood in the filtering version.
•
Check (for transport reasons) that there is no other
supplied material inside the hood (e.g. packets with
screws (*), guarantees (*), etc.), eventually removing
them and keeping them.
Expansion wall plugs are provided to secure the hood to most
types of walls/ceilings. However, a qualified technician must
verify suitability of the materials in accordance with the type of
wall/ceiling. The wall/ceiling must be strong enough to take
the weight of the hood.
Do not tile, grout or silicone this appliance to the wall.
Surface mounting only.
Operation
The hood has two operating modes: Fumes Extractor (A) and
Air Purifier with HEPA filters (B).
The two operating modes use two different motors and the
hood is programmed in such a way that both operating modes
cannot be simultaneously activated, see also the chapter
"Fumes Extractor motor (A) and Purifier motor (B) Priority
Management"
T1:
FUMES EXTRACTOR (A) - speed 1 selection key
Press to activate the low speed (extraction power); Press
again to turn the extractor off.
T2:
FUMES EXTRACTOR (A) - speed 2 selection key
Press to activate the medium speed (extraction power); Press
again to turn the extractor off.
T3:
FUMES EXTRACTOR (A) - speed 3 and "BOOST"
selection key
Press once to activate the high speed (extraction power);
Press again to switch to "BOOST" speed. The LED T3 will
start flashing.
When the booster is on, it is possible to switch to the first or
second speed by pressing the desired speed button T1 or T2.
When the booster is on, press T3 again to turn the hood off.
After 5' the booster automatically turns off and the third speed
is automatically activated.
T4:
Light ON/OFF key
Press to activate / deactivate lighting on the TOP.
T6 PURIFIER (B) low speed selection key
A short press activates the Air Purifier at low speed,
A long second press (2 sec.) activates the motor in timed
mode. The LED T6 will start flashing, the motor will
automatically turn off after 6 hours. To stop the timed mode at
any time, press T6 again
If T6 is pressed a second time with the timer deactivated, the
Purifier motor will turn off.
T5 PURIFIER (B) intensive speed selection key
Press to activate the Air Purifier at intensive speed.
Press T5 again to turn the Purifier motor off.
Note: this speed is always timed at the end of the 40 min,
after which the speed switches to the first purifier speed (the
one normally activated with key T6), and 6h timing will start
automatically.
Motor "DELAY OFF" Mode:
A long press of key T1 / T2 / T3 activates automatic motor
power-off.
The motor will turn off after the following time period:
T1 = after 20 minutes;
T2 = after 15 minutes;
T3 = after 10 minutes.
Notes: This function cannot be programmed for the "BOOST"
speed. When Delay OFF is active, pushing the key of any
speed will disable the function.
Fumes Extractor motor (A) and Purifier motor (B) Priority
Management:
The Fumes Extractor motor (A) has priority over the Air
Purifier with HEPA filters motor (B).
With motor (A) and (B) in OFF: either of the two motors can be
activated at any time.
With Fumes Extractor (A) active:
- If the Fumes Extractor (A) is running, pressing keys T6-T5
will activate the "DELAY OFF" mode of the Fumes Extractor
motor (A), and the Purifier will automatically turn on following
the operation of the "DELAY OFF" mode. In this case, the
LED of the active speed T1 / T2 / T3 will start flashing and the
LED of the selected T5 or T6 key will light up steady
If the Fumes Extractor (A) is running and activation of the
purifier has already been programmed, a second long press of
key T6 in low speed will cause the Purifier to automatically
turn on in timed mode, following the operation of the Delay
OFF mode. In this case the LED of the active speed T1 / T2 /
T3 will start flashing together with the LED of key T6.
Purifier (B) active:
- If the Purifier (B) is running, pressing keys T1-T2-T3 will
cause the Purifier (B) to immediately turn off, and the Fumes
Extractor
motor
8
(A)
will
be
activated
Publicité
