Télécharger Imprimer la page

NEC MultiSync FE1250+ Mode D'emploi page 13

Publicité

Les langues disponibles

Les langues disponibles

Specifications
Monitor
Specifications
Picture Tube
Viewable Image Size:
Input Signal
Analog input:
Display Colors
Horizontal:
Synchronization
Range
Resolutions Supported
Resolution based on horizontal and
vertical frequencies only
Horizontal:
Active Display Area
(Factory Setting)
Active Display Area
(Full Scan)
Power Supply
Current Rating
Dimensions
Weight
Environmental Considerations
Operating Temperature:
Storage Temperature:
FE1250Plus.wpc
MultiSync
FE
®
Monitor
Diagonal:
22 inch/55 cm
20 inch/51cm
Radius:
50000 mm
Video:
ANALOG 0.7 Vp-p/75 Ohms
Sync:
Separate sync. TTL Level
Horizontal sync. Positive/Negative
Vertical sync. Positive/Negative
Composite sync. (Positive/Negative) (TTL Level)
Unlimited number of Colors
30 kHz to 110 kHz
Vertical:
50 Hz to 160 Hz
640 x 480 @ 50 to 160 Hz
800 x 600 @ 50 to 160 Hz
1024 x 768 @ 50 to 132 Hz
1280 x 1024 @ 50 to 101 Hz
1600 x 1200 @ 50 to 87 Hz ...................... NEC-Mitsubishi Electronics Display cites
1800 x 1350 @ 50 to 77 Hz
1800 x 1440 @ 50 to 73 Hz
1856 x 1392 @ 50 to 75 Hz
1920 x 1440 @ 50 to 73 Hz
396 mm/15.6 inches
Vertical:
297 mm/11.7 inches
406 mm/16.0 inches
305 mm/12.0 inches
AC 100 – 120 V/220 - 240 V, 50/60 Hz
1.3A @ 100 – 120 V / 0.6A @ 220-240 V
495 mm (W) x 493.5 mm (H) x 473 mm (D)
19.8 inches (W) x 19.7 inches (H) x 18.9 inches (D)
29.7 kg
65.5 lbs
+10°C to +35°C/+50°F to +90°F
Humidity:
30% to 80%
Altitude:
3,000 m/10,000 Feet
-20°C to +60°C/-4°F to +140°F
Humidity:
10% to 90%
Altitude:
15,000 m/50,000 Feet
NOTE: Technical specifications are subject to change without notice.
11
13
Notes
1250+
90° deflection, 0.24 mm grille pitch,
medium short persistence phosphor,
aperture grille CRT, G-WARAS coating
Depends on display card used.
Automatically
Automatically
Some systems may not support
all modes listed.
recommended resolution a 85 Hz for
optimal display performance.
Dependent upon signal timing used,
and does not include border area.
Dependent upon signal timing used,
and does not include border area.
12/6/00, 10:32 AM

Publicité

loading

Ce manuel est également adapté pour:

Multisync fe1250+-rMultisync fe1250+bk-r