Virutex EVOLUTION PEB250 Mode D'emploi page 34

G
K
B
A
(Fig. 16-3)
C
(Fig. 16b)
34 - PEB250 EVOLUTION
E
F H
J
I
D
Indicates that the main switch is in the ON position.
C - Decrease pushbutton for temperature selection.
Pushing it lowers the temperature.
D - Increase pushbutton for temperature selection.
Pushing it raises the temperature.
E - Selected temperature. It displays the selected operating
temperature. It also displays the safety alarms and mainte-
nance warnings.
F - Real temperature reading.
Displays the real glue temperature at all times.
G - Machine status indicator LED (Green).
This LED will remain off while the glue is heating up. When the
temperature shown on screen F reaches the preset temperature
less 5ºC (41ºF), a double Beep noise will be heard and the LED
will come on.
H - LED (green). The elements that heat the glue tank are
operating intermittently. The LED is on when the elements are
receiving the current.
I - LED (green). Indicates that the motor can be started so that
the glue starts to move up through the gluing roller. The LED
comes on when the glue temperature reaches 110ºC (230ºF).
J - LEDs (yellow) indicating the working speed. When the working
speed changes, this will be shown by the corresponding LED.
K- Led (red) indicates that fuse K (Fig. 16-3) on the machine
has blown.
Change of temperature scale ºC – ºF: To change the temperature
scale from ºC to ºF or vice versa, you must keep the pushbuttons
C and D pressed (Fig. 16-3), while the lead for the machine is
plugged into the mains. The scale will change each time that
you repeat this operation.
10.2 Extraction
The edge bander is equipped with an extraction port to which
the extraction hose with connectors (Ref. 8299567) can be
connected for any Virutex vacuum cleaner. To do this, remove
the protective cap and insert the hose with connector into the
extraction port of the edge bander (Fig. 16b).
Precautions when using PUR and EVA glues:
PUR glues can contain different types of isocya-
nates, some of which can be toxic.
To prevent potential health risks, follow these
precautions:
- Ensure good ventilation in the workplace.
- Use respiratory protection.
- If using PUR glues, connect the machine to an extraction
system.
- Observe national regulations and follow the recommendations
and warnings of the glue manufacturer.