Virutex EVOLUTION PEB250 Mode D'emploi page 33

B
(Fig. 12)
D
C
(Fig. 27)
B
(Fig. 14)
E
F
A
B
C
A
D
E
To glue larger pieces, or to glue a series of items, you must
wait about 20 minutes for all the granulate to melt. (Open the
cover B (Fig. 12) to check this).
Ensure that all the adjustments in points 8 and 9
below have been performed before continuing.
Next, place the guide plate A (Fig. 27) over the piece to be
edged B (Fig. 27) and move the pressure roller C (Fig. 27) close
to the piece but without touching it.
Hold the machine over the piece with your right hand and move
the edge with your left hand through the guides E (Fig. 27), to
the advance roller F (Fig. 27). The edge will be automatically
fed through to pressure roller C (Fig. 27).
When the edge appears between the panel and the pressure
roller C (Fig. 27), allow around 2 cm of edge to pass with res-
pect to the panel and press roller C against the edge and the
panel (Fig. 26). The edge will stick and the turning movement
of the pressure roller will move the machine forward (Fig. 26)
continuously and consistently, at a speed of between 2 and
6 metres/minute according to the difficulty of the piece, and
this can be selected using handle A (Fig. 14). The selected speed
will be shown by the corresponding yellow LED D (Fig. 14).
Do not try to go faster, maintain steady pressure on the pressure
roller and let the machine move at its own pace.
Should an edge get stuck, it must always be removed
in the same direction as the machine moves it. Never
pull an edge backwards, as the pressure roller and
the feed cylinder will become dirty from contact
with the glue.
We recommend gluing some test pieces first to practice using
the PEB250.
Check and refill the glue tank regularly.
Functions and indicators on the Control panel (Fig. 16-3)
A - Main switch.
The machine's electrical supply is connected in position ON and
disconnected in position OFF. In addition, pressing it once will
eliminate all the warnings and errors. Keeping it pressed down
for 2 seconds will disconnect the machine and the word OFF
will appear on screen F.
B - White LED.
PEB250 EVOLUTION - 33