Bosch W 160-5 P Notice D'installation Et D'entretien page 32

Explanation of symbols
1 Explanation of symbols
1.1 Explanation of symbols
Warnings
Warnings are indicated in the text by a warning triangle
with a grey background and are framed.
Keywords at the start of a warning indicate the type and seriousness of
the ensuing risk if measures to prevent the risk are not taken.
• NOTICE indicates that material damage may occur.
• CAUTION indicates a hazardous situation which, if not avoided,
could result in minor to moderate injury.
• WARNING indicates possible severe personal injury.
• DANGER indicates that personal injury with a danger to life may
occur.
Important information
This symbol indicates important information where
there is no risk to people or property. It is separated by
horizontal lines above and below the text.
Additional symbols
Symbol Meaning
▶ Action step

Cross-reference to other points in this document or to
other documents
• Listing/list entry
– Listing/list entry (2nd level)
Table 1
1.2 General safety instructions
General
These installation and maintenance instructions are
intended for specialists.
Failure to observe the safety instructions can result in
serious injuries.
▶ Read and follow the safety instructions.
▶ Observe these installation and maintenance
instructions to ensure trouble-free operation.
▶ Install and commission heat sources and their
accessories according to the relevant installation
instructions.
▶ To reduce oxygen permeation and therefore
corrosion to a minimum, do not use vapour-
permeable components! Never use open, vented
expansion vessels.
▶ Never close the pressure relief valve.
32
2 About the product
2.1 Intended use
The DHW cylinder is designed for heating and storing potable water.
Observe national, regional, and local codes, regulations, guidelines and
standards for potable water.
Install this DHW cylinder only in sealed unvented systems.
Any other purpose is considered improper use. Any resulting damage
from prohibited usage is excluded from liability.
Requirements for potable
water
Water hardness, min.
pH value, min. – max.
Conductivity, min. – max.
Table 2 Requirements for potable water
2.2 Data plate
The data plate is located at the top rear of the DHW cylinder and includes
the following details:
Item Description
1 Model designation
2 Serial number
3 Actual capacity
4 Standby heat loss
5 Volume heated by immersion heater
6 Year of manufacture
7 Corrosion protection
8 Max. DHW temperature, cylinder
9 Max. flow temperature, heat source
10 Max. flow temperature, solar
11 Connected electrical load
12 Heating water heat input
13 Heating water flow rate for heating water heat input
14 Output volume at 40 °C electrically heated
15 Max. operating pressure, on the domestic hot water side
16 Highest design pressure
17 Max. operating pressure, heat source side
18 Max. operating pressure, solar side
19 Max. operating pressure on the domestic hot water side, CH
20 Max. test pressure on the domestic hot water side, CH
21 Max. DHW temperature with electric heating
Table 3 Data plate
2.3 Supplied parts
• Hot water cylinder
• Installation and maintenance instructions
W 120-5 P | W 160-5 P | W 200-5 P | W 200-5 EP – 6 720 821 084 (2022/03)
Unit
ppm 36
grain/US gallon 2.1
°dH 2
6.5 – 9.5
μS/cm 130 – 1500