Operating Instructions; Adjust The Stapling Gap - Signode JOSEF KIHLBERG JK35T590 Mode D'emploi

6
1
Fig. 4
05.20

OPERATING INSTRUCTIONS

During operation, the pliers' gap is fixed. If necessary
the gap can be set to accommodate different material
thicknesses. Spacers with 3 and 6 mm thickness are
available. These spacers are delivered with the tool,
together with a set of longer screws to be used when
spacers of more than 3 mm total are inserted.
– Unscrew the four screws (Fig. 4/1) and remove.
– Measure the work peace and add 1–2 mm.
– Adjust with 3 and 6 mm spacers so you receive
this space between the nozzle and the tounge.
– Check so the pliers can be moved easely at the
work peace.
– Adjust the anvil as described in chapters 7.4 and
7.5.
Josef Kihlberg JK35T590

6.1 ADJUST THE STAPLING GAP

Be sure that the tool is not pointing at
yourself or anyone else when connec-
ting it to the compressed air line.
7