Control The Clinch; Adjust Staple Clinch - Signode JOSEF KIHLBERG JK35T590 Mode D'emploi

1
2
Correct
3
To long staple
To short
Fig. 9
1
Fel
2
Fig. 10
1
Fig. 11
05.20

7.4 CONTROL THE CLINCH

1 Good clinch.
2 Leg length of the staple too long.
3 Leg length of staple too short.
Always use Josef Kihlberg original
staples: JK590-19 up to 32 mm.

7.5 ADJUST STAPLE CLINCH

Each plier is tested carefully before delivery. By rough
treatment during operation the anvil therefore might
need to be adjusted. Uncorrect clinching may then
occur (Fig. 10/1).
– Dissassemble the door.
– Insert a lose staple into the nozzle (Fig.11/1).
– Unscrew the four screws on the rear of the anvil a
1/4 turn. Push a staple to the anvil and adjust the
toungue so that the staple hits the anvil hollows sym-
metrically.
– Then tighten the screws.
– Assemble the door.
– Make a test-stapling in a piece of carton. If the anvil
is correct adjusted the clinch should be like in
(Fig. 10/2).
Josef Kihlberg JK35T590
11